-
-
84.
This video demonstrates the movement of the gears in an assembly and
discusses
some of the theory involved in the design of this gear set.
Back
to the top-
-
85.
This video describes how to sketch out the start of the basic geometry
of the
gear
and gear tooth. Back to the top
-
86.
This video describes more on how to sketch out the start of the basic
geometry
of the gear and gear tooth profile.
Back
to the top
-
87.
This video describes more on how to sketch out the basic geometry of the
gear
and gear tooth profile. Back to the top
-
88.
This video describes how to put all of your gear related parts into an
assembly
to test the Physical Dynamics and motion.
Back
to the top
-
89.
This video provides an introduction by looking at a finished drawing and
describing
the various annotations used.
Back
to the top
-
90.
This video discusses a document on our website that provides definitions
to
precision,
tolerances and dimensioning strategies.
Back
to the top
-
91.
This video describes an assembly showing parts with mating surfaces with
interferences
and clearances and the concepts behind Least Material Conditions
and
Most Material Conditions.
Back
to the top
-
92.
This video describes more on an assembly showing parts that meet 2
dimensional
tolerances but still have mating surfaces with interferences showing
the
need for 3 dimensional tolerancing.
Back
to the top
-
93.
This video describes the concepts and use of datums and Feature Control
Frames.
Back to the top
-
94.
This video describes symbols in Feature Control Frames and some online
resources.
Back to the top
-
95.
This video describes how to set up your sketch using Sketch Picture then
starting
the Auto Trace tool for the outline sketch.
Back
to the top
-
96.
This video describes more on some of the options for Sketch Picture and
the
Auto
Trace tools. Back to the top
-
97.
This video describes how to use Sketch Picture to model a car with better
practices
and tips. Back to the top