-
1.
This video provides instruction on how to create your millimeter SolidWorks
template
file. Back to the top
-
2.
This video provides instruction on how to make modifications to your millimeter
template
file and how to use that file to create an inch template file.
Back
to the top
-
3.
This video describes some of the elements in the Feature Manager including
the
three primary planes, origin and various view settings.
Back
to the top
-
4.
This video demonstrates how to start sketching and introduces and describes
some
of the sketch elements visible on the screen.
Back
to the top
-
5.
This video demonstrates how to make our first 3D feature out of our sketch
and
how to sketch the geometry for some side holes.
Back
to the top
-
6.
This video demonstrates how to cut our side holes out of our sketch.
Back
to the top
-
7.
This video demonstrates how to use the Fillet and Shell features on our
box
and
the differences in how things are ordered in the Feature Manager.
Back
to the top
-
8.
This video demonstrates how to use the Hole Wizard and the sketch geometry
involved
with hole placement to finish our model.
Back
to the top
-
9.
This video demonstrates how to sketch half the of a T-Section then using
the
Mirror
Entities command for the other half before extruding the enclosed geometry.
Back
to the top
-
10.
This video demonstrates how to sketch the outline of a T-Section followed
by
Offset
Entities (offsetting those lines) followed by the Trim Entities command
(to
trim the excess) before extruding the enclosed geometry.
Back
to the top
-
11.
This video demonstrates how to insert a Cosmetic Thread into your model
and some of the options available. Back to the top