-
126.
This video provides a front to back introduction and discusses the mating
relationships
and some of the modeling techniques with each of the parts involved.
Back
to the top
-
127.
This video briefly discusses scenes and the perspective view then jumps
into
the
base sketch of the Meter Cap.
Back
to the top
-
128.
This video shows how to use sketch geometry (circles, construction lines,
arcs)
in
a single sketch on top of the Feature manager Design Tree that will drive
many
of
the subsequent features of the Meter Cap model.
Back
to the top
-
129.
This video shows how to start the Meter Cap using the extrude with a draft,
cut
with a draft and the Shell Feature. It also demonstrates how to use the
Section
Command
to help facilitate modeling.
Back
to the top
-
130.
This video demonstrates the Hole Wizard and the Straight Slot and Arc Slot
Sketch
Entities to finish the Meter Cap.
Back
to the top
-
131.
This video demonstrates how to start the base sketch on the Meter Base
part
using
sketch geometry involving circles, arcs and center-lines.
Back
to the top
-
132.
This video demonstrates how to use the base sketch of the Meter Base to
Convert
Entities and to use features using Select Contours and the up to next option.
Back
to the top
-
133.
This video demonstrates how to the Hole Wizard and Cosmetic Threads then
apply
these items with the Slot Cut in a Circular Pattern on the Meter Base.
Back
to the top
-
134.
This video demonstrates on the Meter Base how to create a simple mounting
tab
with a Hole Wizard and a Linear Pattern.
Back
to the top
-
135.
This video demonstrates how to put the Meter Base and Meter Cap into an
assembly
and the steps involved. It also describes how to use the toolbox to
insert
fasteners and how to select scenes and use the perspective view.
Back
to the top